Boost Your Mustang’s Performance: Remove the Smog Pump in Minutes

If you own a classic Fox Body Mustang (1979-1993), you know every bit of horsepower counts. Removing the restrictive smog pump is one of the easiest ways to unlock better throttle response and clean up your engine bay. With the Smog Pump Eliminator Bracket With Idler Pulley 68110, you get a direct-fit replacement that keeps your belt routing intact—no guesswork, no extra modifications.

Why You Need to Remove Your Smog Pump

✅ Gain More Power – Reduces parasitic drag, letting your engine breathe and perform better. ✅ Cleaner, More Organized Engine Bay – Get rid of unnecessary clutter and make future maintenance a breeze. ✅ Eliminate a Common Failure Point – Old smog pumps wear out over time. Replace it with a reliable solution.

Simple, Step-by-Step Installation

You don’t need to be a pro mechanic to install this kit. Just follow these quick steps:

1. Disconnect the Battery – Safety first! Always remove the negative terminal.

2. Loosen the Belt – Use a serpentine belt tool or pry bar to release tension and slide the belt off the smog pump pulley.

3. Remove the Smog Pump – Unbolt the pump and disconnect any attached hoses. Save the bolts!

4. Install the Eliminator Bracket – Use the factory bolts to secure the Smog Pump Eliminator Bracket With Idler Pulley 68110 in place.

5. Reinstall the Belt – Check if the stock belt fits; if not, swap in a shorter one.

6. Verify Alignment & Tension – Make sure everything is properly seated and tensioned.

7. Start Your Engine – Run a quick test to ensure smooth operation.

Upgrade Your Mustang Today!

Stop letting a restrictive smog pump rob your Mustang’s performance. Get the Smog Pump Eliminator Bracket With Idler Pulley 68110 now and enjoy a smoother, more powerful ride.

🛒 Order Now – Limited Stock Available!